View Single Post
 
 
Posted 2003-10-03, 11:44 AM in reply to Kuja`s #1's post "Ps2"
before screwing with the voltage u might try adjusting the white cog which adjusts the angle between the disk itself and the rails on which the laser assembly sled runs, 1 or 2 clicks each time and then test if it works (before u begin mark the point where u start with a marker), this is what I needed to do when my ps2 was giving DRE's


Last edited by undeadzombieguy; 2003-10-03 at 11:47 AM.
Old
Profile PM WWW Search
undeadzombieguy is neither ape nor machine; has so far settled for the in-betweenundeadzombieguy is neither ape nor machine; has so far settled for the in-between
 
 
undeadzombieguy